Questions & Answers for: wire sub 8 terminals

...wire the sub for an 8 ohm load. To do this, the amp's (+) wire should go to the (+) terminal on one of the sub's voice coils. Then run a wire from the (-) terminal on the OTHER voice coil to the (-) ...

...wire the dvc's @ 8 hom's to run the amp at 2 hom's? also my other question is if i ran paralell sub A pos terminal1 to sub A pos terminal2 to sub B pos term1 to sub B pos terminal 2 to the amp and so ...

...sub to 4 ohm. Now lets say you have 2 subs that are dual 4 ohm and wire both of them + to + and - to - and go bridge the amp which would be both wires from sub both + together and both - wired bridge ...

...wire, the sub has not worked. Everything is tightly connected. What could be the problem? I would double-check your RCA's on the amplifier. You should hear a thud if you unplug them. If not they are ...

most folks probably don't want this). By wiring in parallel (+ to + and - to - and connect the - wire to the - terminal on your amp and the + wire to the + terminal on your amp you'll have a 2 ohm sub

...8 ohms. If you have a pair of 4 ohm subs, wire all 4 positive terminals to the positive terminal on the amp and the sam with the negative sides. The key is to use the same length of wire on all ...

...sub = 2 ohms wired parallel and 8 ohms wired in a series......this means if you have two dual 2 ohm subs or if you have one dual 4 ohm sub you are not going to be able to get a 1 ohm ...

...wire a single sub at 4 ohms? which speaker terminals would i use? If your single sub is a 4 ohm sub, you just connect + and - on the amp to the corresponding + and - terminals on the sub. If it's a ...

...wire this dual 4 ohm sub in parallel or series. Parallel wiring would be to wire two the positive terminals on the sub to each other and wire two the negative terminals on the sub to ...

8, 4 or 2 ohms depending on which sub I checked. So I took the sub out of the box thinking there must be something I did wrong. All the wires where right, so I checked the terminals on the sub itself