Questions & Answers for: wire power fishfinder

Question about A65 Combo GPS Chartplotter/Fishfinder

2 Answers

...power lines, drilled a suitible hole for at soft cable with 2 wires. Soldered and insulated the 2 wires. Finally I filled up around my drilled hole with epoxy and fitted a connector in the other end ...

Ad

Question about Color Fishfinder 160c

1 Answer

...power to the unit. The red positive wire goes to a positive terminal on your battery or positive side of a bus bar or switch, the black negative wire goes to the negative terminal on the battery or ...

Ad

Question about Fishfinder 565 With Transom Mount Transducer

1 Answer

WIRE THE RED AND BLACK WIRES OF THE POWER CORD Yes you can. Basically the red wire goes to the fuse box connection. The fuse box should then be wired into the positive battery terminal. The black wire

Question about Gsd 21 Sounder Blackbox Fishfinder Module

1 Answer

...transducer. The gsd 21 and 478 powers up but the gsd 21 flashes 1 sec on 1/2 sec off signaling a wireing problem, the gsd 21 does not have instructions for a 478 so I used the wireing diag for the ...

Question about Fishfinder 160 GPS Receiver

1 Answer

IS POSITIVE, NEGATIVE, ON THE THE WIRE (AKA POWER DATA CONNECTION) Download the Garmin GPS to PC Wiring Instructions from their site and you'lll see the pin configurations. Then tun off your Caps Lock

Question about Fishfinder 90

1 Answer

...power cable wire on my Garmin Fishfinder 90. With the boat out of water, should the depth reading on the Garmin be flashing "0.0"? possibly.most ive owned will flash random numbers when out of the ...

Question about X96 200khz Fishfinder

1 Answer

...wire or a bad connection. Are you also sure the voltage drops to 7volts? Where? On the finder? Did you check also the where the finder's power wires are connected to the main power wires? A VOM would ...

Question about Fishfinder 90

1 Answer

...wire (power in, pins ....) cable two: red + black + green + white + an ancoated wire (probably ground) Fortunately I found another cable, that looks perfect, with two exit lines (Copartner LL84021), ...

fishfinder. Erkki I want to connect Garmin transducer with it and make a new power cable because I lost old one. I dont know which pins in connector goes where when connecting cables. Here is the link

...on the cable plug end? I have 2 there & the Garmin unit has 4 female sockets. You lost your power wires + & - or blown a fuse. The other two are the transducer

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top GPS Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66931 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a GPS Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...