...for a bind. Look for missing parts. To check the solenoid for bad internal contacts, disconnect all wires going to the back of the solenoid. Mark which ones go where. There are "back nuts" on each ...
...mesh with the ring gear. You should be able to pull on the plunger that goes into the solenoid and feel the starter drive move forward and backwards freely. Install the solenoid and connect all ...
...the bodywork, while the new airbox side covers incorporate air scoop inlets covered with woven wire mesh. The silver five-spoke cast aluminum front and rear wheels are a new design for the V-Rod
Question about 2000 FLHRCI Road King Classic
...wire on the solenoid and if the solenoid is okay it will engage the starter drive and turn the starter over. If the solenoid is not good this will not happen. If you were to bring power directly to ...
...wire mesh air filter element and the breather tubes in lukewarm water with a mild detergent, do not strike the filter element on a hard surface to dislodge dirt, allow the filter to either air dry or ...
Question about 2000 FLHRCI Road King Classic
...would spit, sputter and knock off and not restart for about 30 minutes. I replaced the coil, coil wires, plugs, now it will start but runs rough and is backfiring but only on the back cylinder, no ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions