Questions & Answers for: Chevrolet Suburban how wire

After putting in starter, attaching wires is HARD, any tricks to attaching wires?? Putting in a new starter, but trying to attach the wires is very hard; any tricks to the trade? should I put the ...

Removing spark plug wires without damage to the wire. I cannot seem to get the wires loose from the spark plugs in order to replace the plugs. I am afraid I will damage the wire if I usr too much ...

...hassle of possibly replacing a good motor to find out it still won't blow. To check motor: unplug wire connector from the resistor, (located under right side of dash, should be two wires coming out ...

...first check fuses, then check your brake light switch, with a test light to ground check orange wire is light on if it isn't check your fuse. if it is ,touch your white wire and press brake pedal ...

...into the tank? easy ,take pipe off under the bonnet that feeds the injection system ,then run a wire direct from the battery to the live wire on the pump ,on top of the sender unit under the seat ...

when I replaced the starter in 1992 chevy suburban the small wire that goes to the cylenoid is it supposed to have constant power? If the wire goes to the alternator, then yes. The wire from the ...

...code wiring for radio 1996 Chevrolet Suburban Car Stereo Radio Wiring DiagramRadio Constant 12V+ Wire: OrangeRadio Ignition Switched 12V+ Wire: YellowRadio Ground Wire: BlackRadio Illumination

mangled wire in window motor for 2001 chevy suburban. Can we just replace the wire? If so how to feed it into the motor assembly? The motor works fine. The window falls....But there was a horrible ...

2002 Chevrolet pump square connector has a black wire,orange wire, grey wire and purple wire. What's does each wire go to? the Fuel Pump?

...causes - have you looked for trouble codes (DTCs) with a code reader? REALLY sounds like a loose wire! There are many places a loose wire could cause this. For example, a body plug harness on the ...