Questions & Answers for: Acura TL wipers dont work

...wipers on my 1996 Acura 3.2 TL stopped working. When I turn them on, they do not wipe the windshield. Every now and then they will work once or twice then stop again. If I pull the wiper blade across ...

...fitted the blades when the wiper motor wasnt in park ok remove wiper arms turn ignition on turn on wipers then turn of by wiper swicth not key motor will stop in park position fit wiper arms in ...

...wipers don't work right. Try to and then stop. 1996 Acura 3.2 TL what is wrong? YOUR WIPER MOTOR COULD HAVE BINDING LINKAGE AND PIVOTS.TRY LUBRICATE THEM WITH WD40.TRY NOT TO GET ANY ON WINDSHIELD.IF ...

...wipers stoped working i think it is a fuse. [email protected] COULD BE FUSE.IF FUSE GOOD.CHECK TO SEE IF POWER GOING TO WIPER MOTOR.IF YES.REMOVE WIPER MOTOR HOT WIRE IT USING JUMPER WIRES TO CAR ...

...replaced the wiper switch still dont work Have you checked the fuse? It could also be the wiper motor itself. You should test for power at the motor. If it has power, then the motor is probably

where is the location of acura tl 2004 wiper motor? The wiper motor is located in the left rear of the engine compartment near the corner by the driver side. Remove the wiper arm assembly (both if ...

...do that so the motor doesn't burn up when wiper is froze to windshield and cannot break loose. With wipers off push down at base of wiper arm and then re tighten the 14 mm nut holding arm to ...

...wipers would only go half way and stop, they would only work in continuous mode. now the wiper fuse keeps blowing weak or faulty wiper motor, or wiper motor under heavy load, clean out snow ice and ...

location of the cowl panel on a 2000 Acura TL motor is running but the wipers dont move alldata.com

...wipers don't work, motor is good, fuses are good, only the sprayer work This is a classic trouble shooting issue. You need to "follow" the electricity by testing that the wiper switch has power, that ...