Questions & Answers for: wiper arm going far

...wiper arm and it'll snap back down where it belongs. It's probably more trouble than it's worth, since your change will cause the wiper to cover less of the windshield once you turn them on. (since ...

...off the key 30 sec later, move the wiper arm to the park position, then remove the caps plastic caps at the start off the wiper arm ( if fitted) and then tigthen the nut there and that should fi ...

...wiper arm and moter. The promblem is not with your wiper motor, that I am 99.9%, however the issue is probraly with your wiper linkage bar, depending on what car you are talking about. Either the ...

wiper arm itself. Where the arm mounts to the wiper transmission (aka motor), there will be a plastic or sometimes metal cover, gently pull or pry upward on the edge of it to expose the nut that keeps

...wiper has a stem which the arm attaches to.  You would run the wipers to their highest point and turn off the ignition to freeze the sweep of the blades.  Then flip the wiper arms back into ...

...wiper arm and install the left wiper arm in the far left of the wiper movement. Turn on ignition and allow the left wiper to go all the way back to it's rest location at the bottom of the ...

a wiper arm wiper blade keeps going off the window on the passenger side There is no adjustment on this you likely have a worn wiper arm transmission and the extra play causes the arm to travel to far

...wiper arm possibly a plastic cover over the nut remove and remove the nuts while the nuts are removed grab wiwiper at the top and try to jiggle of stud at the bottom sometimes it helps to move wiper ...

wiper arms travel too far when wiping wiper arms travel too far when wiping WIPER MOTOR PROBABLY GOING BAD

...wiper arms their is a 13mm headed nut ,slacken this nut off then using a two legged mini extractor pull the the arm off the shaft then reposition them ,i bought a cheap extractor in the local chinese ...