...arm. Remove the rear wiper motor shaft nut cover. Remove the rear wiper motor shaft nut. Remove the rear wiper motor cover. Remove the rear wiper motor bracket nut. Remove the bolt and the rear wiper ...
...It just leaves the snow on the window. rear wipers are horrid for that... i just bent the wiper arm a little toward the window... works fine Robert Please take a moment to rate this solution ...
...wiper shaft to the driver arm has worn loose. Without taking this apart I can't tell if this can be repaired or tightened or needs to be replaced. Can anyone tell me this? Also, If the shaft and ...
...wiper arm Arm was broken @ the car wash. Purchased new arm; can't seem to get broken arm piece off after removing nut cover and nut.... thanks I have used a small puller to get these off so i didnt ...
arm off because of internal corrosion. I took the wiper blade off to get a little more swing with the arm. I oiled and swung the arm to get it loosened up. Then I bent the arm towards the glass to get
...wiper pivot arm tighten nut to 53 inch lbs. (6 Nm). Install shaft nut cover. Check wiper operation. Good luck (remember rated this post). The wiper motor is located under the black cowl in the front. ...
...base nut needs to be tightned, with the key on and wipers off, now turn key off and position wiper in the park position (down) then tight the nut,remove the cover at the bottom of the arm to see
...wiper arm and remove the nut usually a 13mm nut so you can remove the wiper arm, once arm is off you can remove the screws retiaining the plastic wiper cowl, once cowl is removed you will see air box ...
...wiper arm is firmly attached to the shaft - it sounds like either the wiper came off of the shaft or there is an internal problem with the linkage between the wiper and the motor. Wire would have ...
Usually answered in minutes!
1,139 Questions
1,083 Questions
1,107 Questions
900 Questions
559 Questions