Questions & Answers for: wiper arm

Ad

Question about 1999 Town Car

1 Answer

...wiper mounting arm and pivot shaft (17566) assembly aside. Remove the nuts. Remove the bolt. Position the windshield wiper mounting arm and pivot shaft assembly aside. Remove the windshield wiper ...

Ad

...wiper pivot arm tighten nut to 53 inch lbs. (6 Nm). Install shaft nut cover. Check wiper operation. Good luck (remember rated this post). The wiper motor is located under the black cowl in the front. ...

Ad

...Wiper Arm & Blade Removal & Installation Front To Remove: CAUTION When the wipers are parked (off), the driver?s wiper arm must be above the passenger?s wiper arm. Remove the clip holding the ...

Question about 1997 Blazer

1 Answer

...wiper arm Wiper arm Wiper arm mounting nut To Install: Install or connect the following: Secure the wiper arm with the nut. Tighten to: 17 ft-lb (23 Nm) Nut cover Rear To Remove: Put the wiper arm in ...

Question about 1997 Blazer

1 Answer

...wiper arm on a 1997 suburban, it hits the side of the window. Wiper Arm & Blade (Front) Removal & Installation Wiper Blade To Remove: Turn ignition switch to ACCY position. Turn wiper switch ...

...arm on the wiper motor. Connect the wiper motor electrical connector. Turn the wiper switch to the accessory position. Turn the wiper switch to the pulse position. Turn the wiper switch off when the ...

Question about 1998 Corvette

2 Answers

...wiper arm cowling (refer to the owners manual for the removal of the cowling on your specific vehicle if required). 3. Locate the retaining nut at the bottom of the wiper arm assembly. Some ...

Question about 2000 L-Series

4 Answers

...wiper arm up, pull the wiper back then pull it hard down the wiper arm once the loop releases the wiper. SOME PULL OFF SOME YOU SCREW OFF THERE A SMALL NUT THATS YOU CAN SEE AND UNTIGHTENED IT AND ...

wiper arm away from the window. ----- 2 - With one hand holding the wiper arm press the small tab on the underside of the wiper blade where it meets the wiper arm. ----- 3 - Slide the wiper blade

...arm on the wiper motor.Rotate the washer solvent container into the installation position.Install the washer solvent container screws. Tighten Tighten the washer solvent container screws to 6 N.m (53 ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22331 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...