Questions & Answers for: Dodge window switch

...window lockout switch for continuity in the unlocked position. Replace it if it doesn't have continuity. If the switch test is OK, check for a short or open in the wiring between the affected switch ...

...window switch from the passenger side to the drivers side. Before you do that try with the switch on the up position, wiggle it from side to side. The contacts may be worn and by wiggling it may make ...

...window switch do not work. The drivers side lock switch works but the window switch does not. So the window will not go down with either switch. My sister had a similar problem out of her VolksWagen ...

...rear window control . Power and grounds to the rear switches comes from the master switch. CHECK THE REAR WINDOWS LOCK OUT SWITCH FEATURE ON THE MASTER SWITCH .IT WILL KEEP REAR WINDOW FROM

...that operates that window (i e)left rear window left window switch if it works from the window switch then its the master switch thats bad but if it dosent work then its the motor more than

.... check the window switches. main switch on driver side and the passenger side if window works with main switch .then you have bad switch on passenger side .but if nothing works .it is the window ...

...window switch and run a jumper wire to the TAN wire ground to the BLACK wire then if the switch is working roll the window up if the problem is the switch then jump power to the light/blue wire and ...

...window switch. If the window motor were bad, or if power was not getting to the switch, the window wouldn't work at all. The switch should be tested for correct operation. Remove the switch and ...

...window switch until the window reaches the full up position, then CONTINUE HOLDING THE SWITCH UP for 2-5 seconds, then release the switch. 4) Push down on the drivers window switch until the window ...

...window switch is held to the UP position, the UP circuit is removed from ground and power flows through it, then passes through the UP circuit of the right-front window sub-switch, then to the window ...