Questions & Answers for: Fisher and Paykel can i see the winding diagram of 3 phase motor

Question about Fisher and Paykel Washing Machines

1 Answer

...diagram for the motor of the gentle annie, basically the colour code for the windings This according to googled results, and somewhat verified by me: For the Gentle Annie connect the ...

Ad

Question about Fisher and Paykel Washing Machines

1 Answer

...Phase 1 to 6 - Pump Blocked Error ( No change in the water level) While draining, the water level reading from the pressure sensor has not changed for over 3 minutes. There are three likely reasons ...

Ad

Question about GWL11 Top Load Washer

1 Answer

...Phase 1 to 6 - Pump Blocked Error ( No change in the water level) While draining, the water level reading from the pressure sensor has not changed for over 3 minutes. There are three likely reasons ...

Question about GWL11 Top Load Washer

1 Answer

...Phase 2 to 3 - Display/ Motor Controller. See fault code 106 104. (01101000) Phase 2 to 6 See fault code 106 106. (01101010) Phase 2 to 3 - Display to Motor Controller module Communications Errors ...

Question about Fisher Paykel Intuitive Eco Washer IWL15

1 Answer

...Phase 1 to 6 - Pump Blocked Error ( No change in the water level) While draining, the water level reading from the pressure sensor has not changed for over 3 minutes. There are three likely reasons ...

Question about GWL11 Top Load Washer

1 Answer

...Phase 2, 3 & Phase 4. For Phase 5 and 6 Smart Drivethe nominal resistance should be around 32 ohms.2) Check the Rotor Positional Sensor, Stator brass bridge terminal point andassociated harness ...

Question about GWL11 Top Load Washer

1 Answer

...Phase 2 to 3 - Display/ Motor Control Module. See Fault Code 106 106. (01101010) Phase 2 to 3 and 5 - Display to Motor Control Module Communications Errors (Phase 6 IW Also) These faults are reported ...

Question about Fisher & Paykel Washer

1 Answer

...phase motor with a Start winding, the switch turns off the start winding when it the motor reaches a certain speed. You may be able to repair it yourself by cleaning the motor switch bearing surface ...

Question about Fisher & Paykel Washer

1 Answer

...Motor Control Module. Phase 5 Primary Source: Pump Action: Measure resistance of pump. If resistance is less than 33 ohms, replace pump. Secondary Source: Display Module. Action: Replace Display ...

...3.4.& 8 = 00110001) Phase 2 to 6 - Cold Valve Fault The Motor Controller has measured a voltage from the valve diagnostic circuit that indicates the cold valve is faulty. The most likely cause is ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Fisher and Paykel Washing Machine Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Fisher and Paykel Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...