Question about Featherweight 132Q Mechanical Sewing Machine
...bobbin it is winding under it. How can I fix this? slide plate may be worn - i had the same problem. try holding down the center of the bobbin with a pin while slide plate is in the winding
...Bobbin Winding" but the bobbin does not turn. The machine has not been used for a few months and then when winding the bobbin it would turn slow at first then speed up. How can I fix this problem? I ...
...winding Bobbin winds loosely and doesn't stop when full You need to ensure that the thread is going from the thread spool at the back of the machine, through the eyelet, then around the ...
...bobbin is not winding correctly. The thread is winding under the bobbin. if the bobbin thread is winding around the bobbin winder spindle thenthe bobbin is not sitting correctly on the bobbin winder ...
Question about Quilter's Dream 6003Q
bobbin won't wind and display shows me in bobbin wind mode and won't turn off, so i can't use the machine at all bobbin won't wind and display shows me in bobbin wind mode and ...
...winding new bobbin Problem started after winding a new bobbin. I can sew for an inch or so and then it jams with a big glob of thread. I think the bobbin may not be winding properly. I'm using the ...
Question about Quilter's Dream 6003Q
...bobbin winding. Perhaps the bobbin winder height needs to be adjusted. If you continue to have problems (which I frequently have with some of my machines), I simply use a pencil or a skewer to raise ...
Question about Quilter's Dream 6003Q
...bobbin winding problem. Thread jumps out of the top guide when bobbin is winding. I've tried everything; different speeds, main spool upright,tightening the screw on the thread guide. Take a look at ...
bobbin, but it won't catch the thread to start winding you have to hold the loose end for a few seconds . You should first make about 10 wraps manually with the thread around the bobbin before putting
Question about Quilter's Dream 6003Q
...winding a bobbin, the needle tries to sew. Be sure you are following the instructions completely. However, it sounds like there could have been a problem with the bobbin winding unit since you ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions