Questions & Answers for: Buick Skylark car start bad spark plugs

Question about 1995 Skylark

3 Answers

...one spark plug and see if the car will start if not plug it back in and try the next one, if the car starts after unpluging one of them you have a bad spark plug, hope this

Ad

...start on a 1991 3.8 buick lesabre. 165432 There are six VIN numbers of engines for the 1991 Buick Lesabre, with a 3.8 Liter engine. 1.Vin B 2.Vin 3 3.Vin C 4.Vin 1 5.Vin L 6.Vin K All have the Firing ...

Ad

and module,,,,,,help still no start. Do you have an anti-theft system on this car. That is about the only other thing I could think of besides bad relay or fuse. Since crank sensor and module are good

...car noise first in a ditch 3ft deep half full of water got it out found out he didnt have any brakes got it to start idles good for a couple of min then it gets rough and choucks out cleaned plugs ...

Question about 1993 Skylark

1 Answer

...start. when i first bought car it had this vibration on take off but never could find out what it was. need help Are you getting gas and spark to the cylinders? If you add gas to the throttle body, ...

...car may not perform as well. I think yours takes the fine tipped type of ac delco brand plugs. Start there. Is it possible that you have replaced the spark plug wires or took them off and now the ...

Question about 1994 Skylark

1 Answer

...car runs but is going on 4 working spark plugs...whats wrong with it.. the engine is 3.1 liter. Did you mean coil the 1994 3.1 did not use a distributor , sounds like a bad coil pack and cylinders #3 ...

Question about 1994 Skylark

3 Answers

...car to start if it is malfunctioning or the computer is not reading the resistance right. I had a 1994 cutlass supreme that wouldn't start. I by passed it by getting a resistor with the same ohms ...

...car starts jumping, or acting like its going to lose power. bad spark plug or bad wire will cause one cylinder not fire cause engine to surge.but change spark plugs and wires, if engine still ...

...cleaner in the intake an see if it try's to start , if it try's to start you probably need a fuel pump ! If no spark you have a bad crankshaft position sensor or ignition control module is

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...