Question about Neptune FAV6800AW Top Load Washer
maytag neptne fav 6800 aww does not fill wiht hot water. works fi i checked hoses. pulled hot water hose, cleaned strainer. still not hot water going into tub. bad water in let vavle,,did you check ...
Question about Atlantis MAV6000 Top Load Washer
...spin for safety reasons if it thinks the door is open. If the switch is good test for power at the wigwag (spin) solenoid when in spin cycle. Since it agitates the solenoid itself could be bad. ...
...will not spin sometimes If it's NOT a direct drive machine, then your problem is most likely with the Wig-Wag switch, located on top of the gear case! It ALWAYS goes bad and effects the Spin
dosnt do spin cycle If it's NOT a direct drive machine, then your problem is most likely with the Wig-Wag switch, located on top of the gear case! It ALWAYS goes bad and effects the Spin function
Question about Neptune FAV6800AW Top Load Washer
I just replaced the tub displacement sensor on a Maytag Neptune TL and corrected UC errors, now the unit is stopping during the rinse cycle with a LL code regardless of the load size. If it doesn't do
op is flashing when i try to start a load For the FAV6800A or the FAV9800A you have lost Lid is Open/Lid Is Closed signaling from the Left Hand Lid Lock assembly via the Magnetic Reed relay in that ...
Question about Neptune FAV6800AW Top Load Washer
Maytag Neptune FAV6800AW Top Load Washer? makes a Maytag Neptune FAV6800AW Top Load Washer? makes a loud noise when it spins. more than likely it just needs a little leveling...lift front of washer . ...
Question about Neptune FAV6800AW Top Load Washer
Thje Neptune TL I own will not copmplete a whole cycle. It stops every few minutes and flashes NF. No idea what thois means. HELP!!! Hi Thanks for using FixYa. Error NF means No Fill. The washer has ...
Question about Neptune FAV6800AW Top Load Washer
I have a code "nd" that i can not get to clear. it won't allow the machine to spin out some water that is remaining in the tub. How do i clear this code? Is there any water in the Tub with the ND (No ...
Maytag Neptune FAV6800AWW Washer was working fine then failed to enter spin mode and would not drain after a wash cycle. Repair tech came and said both control board and clutch was bad. What are the ...
Usually answered in minutes!
2,979 Questions
1,498 Questions
947 Questions
680 Questions
658 Questions