Questions & Answers for: GMC wheels

4 wheel drive lights When I turn the 4 wheel drive on in any of the areas other than 2 wheel drive the lights blink and I dont think it is going into 4 wheel drive. are you setting still or driving ...

4 wheel low works but 4 wheel high does not. i bought a used 98 gmc jimmy and when i put the automatic transmission in neutral, then press the 4 wheel high button it does nothing nor does the little ...

...is fixed to the steering column by a screw nut. The steering column has splines, just make sure the wheels are straight, remove the nut and pull of the steering wheel, center the steering wheel and ...

will not go into 4 wheel low I have a 2000 GMC Seirra K2500 4x4. 2 wheel drive is fine. 4 wheel drive hi is fine. When I try to put it into 4 wheel drive low I feel the gears clunk then it goes back ...

I have a 2002 Yukon Denali and I was wanted to know, how do u change the bulb in the steering wheel? Steering Wheel Control Switch Assembly Replacement Removal ProcedureRemove the steering wheel. ...

2003 gmc yukon abs brakes left front grabing and pedal goes to floor like when on ice but on dry pavement and also grinding when turning and seems to be rubbing on inner fender but isn't. I have new ...

rear brakes sticking need more info---did you have brakes worked on, did it happen all of a sudden??? Brake adjusting lever .....star wheel...back plate.Your brake shoe(s) are too tight...they need to

...steering control module uses the inputs listed above to determine when and how far to turn the rear wheels. The rear wheel steering control module also uses the hall switches in the steering gear ...

Are awd drives as good as 4 wheel drive ? Depends on alot of t hings.All wheel drive means all four wheels are pulling all the time.  4 wheel drive means you can shift the transfer case to make ...

...this will be caused by a wheel or tyre problem and to confirm this I would swap the two front wheels over and see if the wobble transfers to the other side. If it does jack up the side with the ...