...back and forth pulling it toward you. There is not supposed to be any movement or noise on the wheel if the bearings are good. if you do see any movement or hear any noises , replace the wheel ...
wheel. There is no noise when car is moving slowly , but past 30km/h noise is increasing proportionate to speed . Thank You ! Victor check your wheel bearings, brakes and backing plate, since you said
...wheel side to side and listen for your noise. 3. If you are not detecting the noise during this test the noise maybe in your power steering system. Also note that sometimes the ball joints may not ...
...of car. maybe a wheel bearing if you are driving and cut the wheel one way the noise should increase cut the wheel the other way noise should go away how far can a car go with a noise wheel ...
Question about Go-Go Elite Traveller Scooter - 4 wheel w/12 AH Batteries & Charger + Flat Free Tires - Silver
...noise in my right wheel. This happens when I am going in forward and reverse. It does not make the noise when I am turning, The noise has seemed to get louder with each use. I have the gogo elite ...
none of the above checks out rotate the tires from front to rear. Did the noise move with the tires or go away? If so you have a bad tire. Cupped tires will make a similar noise to a bad wheel bearing
...noise you have a wheel bearing bad the best way to tell if it is a wheel bearing making noise is while you are driving down the road and the vehicle is making the noise slightly turn the steering ...
wheel bearing If grinding noise is heard coming from front side, lift up both the front wheels and rotate the wheels one by one to listen to the sound, if any. If a noise is heard, replace the front ...
Question about 1998 Tacoma
...noise by spinning wheel by hand. Running in any gear so wheel spins up, produces horrible rattling noise but not from bearing - wheel spins up as expected. When doing the same with the offside, wheel ...
Question about 2004 Santa Fe
...wheel rotation. Noise doesn't occur when brakes applied or when in reverse. Rotors and pads replaced in last 6 months Can be three things worn wheel bearings stone in the brakes (most likely) worn or ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions