Questions & Answers for: wes51

soldering iron troubleshooting are there different types of bits? Bits: It's useful to have a small selection of manufacturer's bits (soldering iron tips) available with different diameters or shapes,

Can't change tip on soldering iron Trying to get tip out of soldering iron. Screw will not screw. Is there some trick I need to know. I am using the iron for leadlighting use small vise grips on edge ...

...You can download the manual from here: ...

its making like a humming noise, what is wrong with it? the transformer screws may be loose, or the plates may have delaminated in the transformer. as long as it is working it should be ok. try ...

i have two WU81 Weller soldering irons and their are both showing the same fault. When we turn the irons on in the morning, the 500mA fuse that can be found in the base unit is blowing. Is this a ...

unit does not heat up to temp and green light blinks hi, i have faced the same problem with my station also. the issue will be only with your 6 pin connector, check whether all the pins are getting ...

...up as well as led is not glowing .i am getting 26 V AC at the output of Transformer for my weller WES51 I had a similar problem. I found that the cable from the transformer to the iron had an open ...

Weller WES51 does not heat up unless I turn to 700 degrees or higher My WES51 has no indicator light nor does it get hot when turning on unless I set the temp to 700 or higher. Once it's around 700, ...

I have Weller EC1002, WES51, and WTCPS all with base, cord, and handpieces (complete). On shelf for years. Can you test, quote and do repairs as needed? yes but shipping alone would eat a lot of ...

pencil is only getting warm. ??? contact weller tech support