Questions & Answers for: Citizen Skyhawk wedge radio stopped working

setting model number jr3060-59f unable to zero hands and reset skyhawk eco drivewatch 1. set mode to CHR with the bezel fully in. 2. pull bezel out 2 notches. This will set all (or most) hands to 12. ...

when i do a full reset the hands go to 2:50 instead of 12 If you are talking about your stopwatchfunction this is probably the solution: pull out the Crown(the one with which you set your normal clock

second does not reset to 12 i have a citizen eco drive watch and the stopwatch hand does not set back to 12, how can i re-calibrate thanks You should be able to solve this by pulling out the Crown(the

...stopped at 12:00 and the left digital read out is flashing UTC and the right digital read out is flashing 12:00. Recharging doesn't seem to help. Is there a reset function? I had the same issue, and ...

I would like a manual to set/make this watch work. I would like a manual to set/make work this Titanium Citizen Sky Hawk Eco-Drive. When I purchased it for my husband, I set it, but after not using it

My watch has stopped My Citizen Skyhawk Tititanium has stopped. The digital readout is flashing. Hi. Go to a shop and ask to replace the battery. Even if the battery can be replaced at home, using ...

UTC Dial does not match Digital UTC readout Utc Dial does not match Digital utc readout and I can't for the life of me figure out how to sync them I finally figured this out... You must zero all the ...

can,t set timeon watch OK try and follow these steps and it may help you set the time on your Watch. Once you understand the different function buttons on the edge of the case setting the time will be

...stopped working and the jewelry store removed the back and battery/capacitor hold down strap. They did not have a replacement. They did not put it back together properly as they did not really ...

radio signal reception alarm Every time the watch gets a radio signal it wakes up the house with an alarm, how do you switch the alarm off or to silace? go to this link for instructions ...