Questions & Answers for: Kia Sedona weak air blowing vents car

...air blowing in the front. However, the rear A/C works fine. All the fans are working. I have even removed the fan in the dash and it worked fine. Is there some sort of relay switch that operates ...

air won't blow cold My air started to not blow cold, then it would make a hissing or whistling noise. Now it just blows hot air. Tried to add freon and it wouldn't take it. Is it the compressor or ...

...air is being moved thru the system. Hope this helps. This Depends on, If the Poor Heat is Defined BY NOT HOT as in Temp. or NOT BLOWING HARD if it is not Blowing Hard This is Most Probably the Bloewr ...

...air blowing hot i have a kia van air in front is working great but in back it is blowing hot what is prob it should ony blow hot from the vent on the floor. this is controlled from a button on the ...

The air conditioning in my 2003 Sedona doesn't work. It appears to operate normally, but the compressor never cycles. The system is serviced and has good pressure. I thought it may be an ...

...blowing luke cold air. The four vents in the back are blowing at 68 degrees. The drivers side 2 are at 80 degrees and the passenger s Just tryind to figure out if it is a leak which the EZ Chill will ...

...blowing out warm air. The only time it shuts off is when I shut the van off. Could this be a hose that came loose or something? Will it blow warm when you are sitting still? or just when the vehicle ...

...air and now in the winter my heat is blowing out cold air. Help please. check that the heater control (tap ) is being turned on by the controls.. Have an accredited ac mechanic check the ac system

air coming from the front vents became really weak/ weaker than it's been (barely anything at all comes out and you don't feel it unless your hand is on the vent) and it seems like it's...blocked? You

time . Now if your talking about the blower inside the car running all the time , air blowing out of the vents . The A/C isn't engaged . Could be blower motor relay stuck or the control module is bad