ignition key will not turn to the on position try spraying wd-40 in switch and try to work key in and out turning it off and on, if that wont fix it the switch is most likely bad, hope to help, thanks
...of a mechanic friend, I checked all the grounds (frame ground and alternator ground) sprayed some WD-40 on each ground and in the actual power clip on the alternator itself and in the battery ...
...sluggish when I accelerate. Try replacing your spark-plugs/wires, cap/rotor, air-filter. Spray some WD-40 on the throttle-body recoil spring.Get a can of carburettor/throttle-body cleaner and spray ...
Won't go into 4WD light blinks then it goes back to 2WD. It's a 3 button system. P.S. It was working yesterday, never had a problem then today it quit. 4 wd actuator motor is bad
where does the vacuum line from the ball mounted on right fender well hook to on a 1989 S10 blazer, 4.3 V6 4 WD the vaccum comes off of the intake manifold behind the throttle body.
...I have to lift it into place with my foot to fully release the brake. Hello: Get a spray can of WD-40 and spray the park brake mechanism under your dash and make sure the park brake cables
main seals need to R & R rear main seals. Best method for completion of task 2/4 WD, man/auto trans?
Question about 2000 S-10
I have a 2000 S-10 with a push button switch for 4 -wd. When the temp is above 40 degrees, I have no problem switching from 2-wd to 4-wd or from 4-wd to 2-wd. But when the temp is below 40, the ...
...Please provide some details on your engine option 4 cylinder/6cylinder 2 WD 4 WD.
Question about 1999 S-10 Pickup
Why does my 99 Chevy S10 keep jumping out of 2wd into 4wd? It don't want to go back into 2 wd with the yellow light lit? My truck keeps going out of 2 wd into 4wd on it's own. I have to keep pressing ...
Usually answered in minutes!
1,473 Questions
904 Questions
790 Questions
747 Questions
686 Questions