Questions & Answers for: waterpump

waterpump removing fan need to remove fan Well, if it's a 5.0L engine, remove the 4 bolts holding the fan to the pulley. If it's a 4.0L engine, you need to hold the waterpump pulley still and break ...

...1997 This is called a weep hole and it indicates the rubber seal is now leaking antifreeze onto the waterpump bearing and it's only a matter of time before the waterpump falls change the waterpump. ...

...hoses and leaking coolant checked radiator hoses and expansion tank all ok take a look at the waterpump, these cars have problems with waterpump leaking, take caution, the waterpump is driven

...steering belt pulley to change the water pump? no, just remove the belt, then the cover over the waterpump then the waterpump pulley,NOTE; loosen waterpump pulley bolts before removing the ...

procedure on changing waterpump first drain the cooling system. loosen bolts on the waterpump pulley and remove the inner fender cover on the pass/side. remove the surpentine fan belt, note; make a ...

...see it coming down in a study stream from under neath the car but not from the radiator. Hello: The waterpump is on the passenger side of engine. Either the heater hoses are leaking or the waterpmp ...

The motormounts are in the way and preventing me from removing the waterpump bolts. I need instructions on how to remove then install a new waterpump on '94 Olds Ninety. Put a jack under the engine ...

how do i tell if my overheating problem is the waterpump on my 2.0 l '96 contour? how do i tell if my overheating problem is the waterpump on my 2.0 l '96 contour? remove coolant ...

waterpump how to replace waterpump pull out your coolant res.pull off your belt.you will see the old waterpump.remove all four bolts.clean off gasket off waterpump mount on motor.place gasket.install.

rodeo waterpump blew now wont start Why after my waterpump blew (is my 4x4 not running now) it wants to fire but wont.. tried jumpstarting and it turned over really quick. It wanted to start but no ...