Questions & Answers for: Kenmore water temp

...temp of the water and put in the manufacture set temp for that setting this board could be bad alowing only cold water to come into the machine. you could also have low hot water pressure at the ...

...water enters the tub. I have tried the rinse temp settings with and without the auto temp control and warm or cold rinse and the same condition applies. I note that if I adjust the rinse temp dial to ...

...water temp works and cold/cold water temp works. Most of my loads I want to use a warm/cold setting but can't because the automatic setting that doesn't work is the only temp setting like that. Don't ...

...water temp switches by itself. I have a Kenmore model 110 top load washer. I never know what the water temp will be while the washing machine is running. The water temp switches by itself in the ...

...temp. control fill valves. If water is too cold the control might mix in some hot to bring up to a preset temp. The same is true when control set for hot. For energy savings cold water will be mixed ...

...water temp on your water heater set high enough? If it is sounds like you are getting water from both hot & cold water valves. If temp is set correctly on machine temp switch may be bad on warm ...

...water temp is determined by 2 things. First the hook up to your water supply. If you are able to turn off the hot water valve that feeds the unit and then select a cold water only wash, do you get ...

water heater temp was set at 140 temp. This heater was replaced with a heater now set at 125 temp. In the past two years dishes are nowhere as clean on the the normal start setting. Should I go to the

water (1/2") in the oven. Turn temp knob to coolest setting and wait for the temp to stabilize. Turn up temp by 1/16 turn and wait for temp to stabilize. Keep repeating until water boils. This is 212F

...temp. of the water is in the drum. The temp.sensor in the drum would need to be checked to see if it is working correctly . To check it you would need to use a multimeter set to ohms and check the ...