Questions & Answers for: water sensor Washing Machines

Question about 1985 Delta 88

2 Answers

sensor on water pump i have a 1985 delta 88 5.0 8cyl.need to know what the sensor is on water pump. Hi there.The only sensor that is down by the water pump is the oil pressure gauge wire.There shouldn

Ad

Question about Duet GHW9150P Front Load Washer

1 Answer

...Water temp sensor failure If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, the "F/05" error code will be displayed. Possible ...

Ad

Question about Duet GHW9150P Front Load Washer

2 Answers

...Water temp sensor failure If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, the "F/05" error code will be displayed. Possible ...

Question about Duet GHW9150P Front Load Washer

1 Answer

...WATER TEMPERATURE SENSOR ERROR If the water temperature sensor (NTC) value is out of range (23°F to 217°F[-5°C to 103°C]) during the water-heating step of the WASH cycle. NOTE: To ...

Question about Duet Sport HT WFW8400TE Washer

1 Answer

WATER TEMPERATURE SENSOR ERROR If the water temperature sensor (NTC) value is out of range (23F to 217F[-5C to 103C]) during the water-heating step of the WASH cycle. NOTE: To find correct Ohm reading

Question about Duet Sport HT WFW8400TE Washer

1 Answer

...water level sensor is defect, or a cable got lose. or the tube connected to the sensor is leaking air. Lots of causes. But please first close the water tap. Then try t drain the water. Perhaps like ...

...water sensor. - Plug in washer or reconnect power. - Verify the washer operation by running the Diagnostic Test cycle. - After the diagnostic test has finished, unplug washer or disconnect power and ...

Question about Aqualink Rs4 One Touch Control System Control System

3 Answers

water sensor open Device reads water sensor open, how can I fix Do you mean your heater is saying water sensor open? Or your control?Whichever one it is , simply replace the sensor, if it's the system

Question about Aqualink Rs4 One Touch Control System Control System

1 Answer

...sensor above water level--say in a bucket of water then lift it out of the bucket if the mains water flows or stops flowing depending on whether the sensor is in or out of the water will indicate it ...

...water heat sensor, but which one is that? And why do we have 3? I'm pretty handy and resourceful, but I cannot for the life of me figure this out. It sounds like you have a hot water heater that has ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...