...water level sensor, please check the hose that connected to water level sensor, make sure no dirt blocking or clogging the hose. also you can clean the tube under the pulsator, usually there is many ...
...water valve, the Float sensor or the Flood sensor. Check the float sensor usually in the front left or center positon of the tub. It should lift and drop for a distanct of about 3/8 inch. If they get ...
Question about WM2487H Front Load Washer
...water sensor located? Error message IE. Sensor might be faulty. Model D1462W The water sensor is a pressure switch that sits on top of the drum and monitors the pressure of air in the drum. As water ...
Question about WM2487H Front Load Washer
...Water Level Sensor at the top of the washer---and to the Air Bell at the bottom of the tub. 2) Remove the black tube from the Water Level Sensor---and blow into tube---to clear a possible blockage. ...
Question about WM2487H Front Load Washer
...water pressure sensor is reporting too much water in tub. It can be bad sensor or too much water is really in the tub. Too much water is caused by water not being pumped out. Kinked line. Bad pump. ...
Question about WM2487H Front Load Washer
...Water level sensor fault This fault code is fairly self-explanatory and tells you that the washing machine has detected an error with the pressure sensor or pressure switch. It is rare to see this ...
...water level pressure sensor to the main control board. - Check for a loose wire harness, a damaged wire harness, or a burnt faulty wire. - Check that you get continuity through the wire harness by ...
Question about WM2487H Front Load Washer
...Water Level Sensor. It is best tested while on the washer---by using the TEST MODE. On most LG washers---the Test Mode is enabled by pressing and holding the SPIN SPEED and SOIL LEVEL buttons---and ...
Question about WM2487H Front Load Washer
...Water Sensor seems to not be working, the water fills up and up it doesnt stop, where can we buy a new Water Sensor, or is it another problem. it possibly is just a dirty ,plugged plastic tube to ...
Question about WM2487H Front Load Washer
water level sensor: The water level sensor is responsible for detecting the water level in the washing machine. If it is faulty, it can cause the E2 error code. To check the sensor, unplug the machine
Usually answered in minutes!
1,845 Questions
401 Questions
404 Questions
243 Questions
245 Questions