Questions & Answers for: Hotpoint water sensor

sensor for the water inside the dryer. you say that even if you already put water in it, the light is still on correct? which means that the dryer does not detect or sense that water is already there.

...water level sensor which sends the electronic signal to the control board to close the valve. There's tiny little pipe going from the top of the drum. at the end of it, the level sensor. Also make ...

...water temperature sensor error. If during the water heating step in the wash cycle, the water temperature sensor (NTC)value is out of range, or the heating element circuit has failed, the F05 error ...

water level sensor, included to check the small hose from the drum to the water level sensor. there must be pressure from the water to suppress these sensors, the operation of the washing machine are:

...water sensor will be ordered to the electronic circuit to run the washer motor. and water level sensors related to the process, from the wash, rinse and drain / spin. it runs sequentially. Hotpoint ...

...water level sensor. IF the sensor does not work then the program controller will not proceed to go to the next cycle as it thinks there is no water to rinse. similar problem when it does not spin or ...

...sensor and cut the power to the water inlet valve, stopping the water flowing into the machine when it reaches the correct, measured level according to the pressure in the pipe. Take the top off the ...

water flow, the input flow sensor might be sending a faulty signal to the control board. In such a case the flow sensor will need to be replaced. 3) Bad control board: If neither of the problems above

...Water Temperature Sensor Error. Does it take long time for the water to get hot when you initially start it? If the water is cold entering the tub when hot water or warm water is selected it possibly ...

...sensor. Water in the drum fills the bottom of the rubber pipe and as the water rises, the air pressure in the pipe increases, which operates a bellows device in the pressure sensor. If the pipe is ...