Questions & Answers for: water overflow

water overflow no problems until yesterday when the water just kept flowing regardless of size setting. I replaced the water sensor and thought it was OK but after 3 loads it overflowed again. I ...

the belt broke, it was replaced, but afterwards its overflows, water overflows, If water is overflowing check the small plastic line going from the bottom of the tank to the water level switch. It ...

...today. Does not seem to be The washer overflowed today. Does not seem to be recognizing when water is full. Also does not run cold water. Overflowing is caused by the pressure switch, it needs ...

...Water bottle should be air-tight to make proper pressure inside bottle. Whenever lose pressure, water overflow with no bubble. Just replace water bottle with no crack or pin hole. Good luck. ...

...water fine when it doesn't overflow. If/when it does overflow, it seems to do so early in the overall cycle. I've changed the overflow control switch but this didn't resolve the problem. What else ...

...overflow tube. The water continues to flow. I read that the water in the tank should be 1/2 " below the overflow tube. Adjust the float on the ball **** to shut the water off at a lower level in the ...

...load? On this model of washer you have 4 separate components that could cause overflowing. The water valve, pressure switch, pressure switch hose & the air dome. If you have to turn the

...of 20 psi to shut off properly. If the pressure is lower, the valve may not close fully when the power is shut off. This results in the valve leaking water into the washer and causing it to

...Water continues to fill and overflow, even tho machine has clicked into its next cycle (agitate, spin, etc)? It has majorly overflowed several times, and we must hover over it and shut water off at ...

...close fully when the power is shut off. As a result, the valve leaks water into the ice maker, causing it to overflow. Check the water flow and test the pressure to determine if it is at least 20 ...