...water pump to see when there is seepage past the seals. Bench bleed the system. With the master cyl. line and slave cyl assembled, place the master cylinder in a vise, fill the master cyllinder. ...
...master cylinder, operating cylinder or connecting lines? Has the fluid level fallen to a point where air could have been drawn into the cylinder? Does the fluid look clean, no particulates?To be ...
master cylinder even though they are less frequent failures. And, don't bother trying to prevent hydraulic fluid loss; you should change it anyhow (it's hygroscopic and will absorb water causing rust)
Question about 2000 Wrangler
master level so you do not run dry) Note: It is advised that brqake linings be replaced after any leak. If you cannot afford, wash linings and drum in strong soapy water & dry off before using. not as
...water, the other possibility is that the pilot bearing is starting to bind this will cause the shifter to not engage as the clutch is pushed in. Not unlike a brake master cylinder, the clutch master ...
...water in the tank? Has anyone changed the fuel filter? Has anyone checked the ceramic ballast resistor on the drivers fender near the master cylinder? Has anyone checked the crank sensor output? Did ...
...water and as a result a soft clutch pedal which is not releasing the clutch No photo, but if you follow the line from the master cylinder for the clutch down to the drivers side of the bellhousing, ...
...water and just shove it on) Open the bleed valve and put the free ind of the hose into a glass jar with a bit of fluid in it (deep hose end submerged) Open the master cover and let the fluid drain ...
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
339 Questions