Question about W100FW Front Load Washer
...washing machine is only filling with cold water not hot? how do i solve this Maybe the pipes are not connected to the heater on the wall. You could heat your water in the machine, if there is a ...
...water each washing cycle and having to stay with the washer each time. It sounds like a siphon issue. Check that the drain hose does a high loop before it goes into the drain pipe. (ie. drain hose ...
Question about Neptune MAH5500B Front Load Washer
water through it while having someone listen to the air vents at the rear of the machine. Air was heard coming from the vents, so my suspicion of an airlock of some sort was put to rest. Any ideas? if
Question about Neptune MAH5500B Front Load Washer
Changed the coupler but now Kenmore Elite doesn't stop filling up I changed the broken coupler and now it doesn't stop filling up! While it was filling up, I blew into the pressure switch and it ...
Question about Neptune MAH5500B Front Load Washer
...water out then remove the back cover to gain access to the pressure switch tube. Possibly it has an airlock. Pull the plastic tube off the drum and carefully blow into both ends. Replace pipe and try ...
...washing machine that stops during rinse node and gives e20 fault (wont drain). I checked the pump - working fine. I've found that if i blow into the waste pipe the machine then starts to drain and ...
my water pipes rattle when water is entering the washer You probably have an airlock in your plumbing, it's unlikely to be caused by your washing machine.
Question about MAH6700AWW Neptune Front-Load Washer
Machine will not drain after final rinse clean the drain pump filter I would take the pump apart and check for a coin that can block the exit tube from the pump housing or into the pump both of which ...
Question about Eco 1584 Submersible Pump - 1584 Gph (Ecoplus)
...water comes from discharge hose Question moved from Washing Machines to Eco Submersible. If it is a submersible pump, it can't be an airlock or a stuck non-return valve. The only likely reason would ...
Question about Eco 1584 Submersible Pump - 1584 Gph (Ecoplus)
...is that the pipe has a blockage, the bore isn't large enough, you have an airlock with water in it, or the fall into the waste pipe isn't steep enough. When it senses any back pressure it faults.
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions