machine out away from the wall and tilt back enough to see underneath. just below the door there is a large concrete weight. chances are it is loose and needs to be tightened. if this problem has been
washing machine the drum in my washing machine is loose and when spinning it bangs around and rubs against the door seal causing smoke to come out when i open the door,can i fix it myself or is a new ...
...drum inside the washer started going crazy and banging up against the glass part of the door. No error codes at all on display. I called LG and they told me it was the ball sensor in my unit. Repair ...
washing machine making a noise as if there is something in it, it sounds as if something is banging against the glass but there is nothing that I can see thats causing this noise sounds like the ...
...machine door and hold the drum (stainless steel bit) try to lift this up if it moves freely without the tub moving (outer bit usually plastic or steel without holes) your bearings are gone. or the ...
...washing machine is revving up to spin and dying down from a spin (suspension problems are also often worse at this stage too). It's not normally a metallic sound though. If the noise is coming from ...
...machine? Front laod washers have a heater element The siemens is mounted at the front of the drum Most likely the heater is burnt out and will need to be replaced. not a difficult problem. The heater ...
...machine is going faster but that possibly the drum suspension is malfunctioning. I would strongly advise first following my general guidance notes to ensure the machine is absolutely stable and then ...
...drum must have banged against the door lock when it was flailing about and could have damaged the door lock???? the actual door lock switch inside the wall of your washer where the door clips in has ...
Question about Nexxt 100 Series WFMC1001UC Front Load Washer
against the motor that is attached to the belt that would drive the drum, I do get it to spin. It just never goes into full speed mode. Is the motor not getting the signal or is the motor the problem?
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions