the pressure will build and slowly go dowe.the the pressure will build and slowly go down.the trigger can be released& it will do the same again the pressure will be good and slowly go down again.
It's acting like it's stopped up. Nothing will It's acting like it's stopped up. Nothing will come out but a trickle You need to have proper water pressure to make it work right. If the pressure is ...
wand leaking at nossal hook up The coupler that the nozzle goes into uses a 1/4" EPDM o-ring. This o-ring needs to be replaced. You can find them at most major hardware stores or purchase them by ...
...washer and you can not start it or.. if you move it with the unit running the oil level sensor kills the ignition. Just make sure that anytime you are going to use it that you ensure the oil level is ...
...washer starts fine and sprays fine but will not continue to idle after nozzle trigger is let go. Have to have trigger pulled to start & cannot let go without unit stopping. The pressure unloader ...
why won't It siphon soap? This is a brand new machine and it will not pull the soap into the machine. The correct nozzle is being used and the proper soap. I have even filled the plastic tube with ...
how do you adjust the pressure? get larger nozzles, if you are using size 4 nozzles now ( looks right for 3 gpm at 2500 psi) then you would use size 4.5 for 2000 psi, size 5 for 1600 psi etc Chart ...
...washer will only siphon from the soap dispenser when you have the low-pressure nozzle attached and then will only sort of dribble out the suds. Good for sudsing, but no good for cleaning. You'll have ...
Dxpw3025 motor drops rpm when triggers pulled Look at the size of your spray nozzle, it may be too small causing excessive back pressure and thus excessive strain on your engine. Your nozzle should be
Usually answered in minutes!
42 Questions
31 Questions
30 Questions
24 Questions
10 Questions