Question about Model 7 Conventional Suction Feed Spray Gun, 1.8mm Tip
Delivers the product but has a pulsating spray Binks Model 7 Delivers the product but has a pulsating spray resulting in a surface that is not uniform. I was spraying lacquer( before there was a ...
Question about Model 7 Conventional Suction Feed Spray Gun, 1.8mm Tip
I have binks model 21 automatic guns on my striper i installed rebuid kits when testing with water the guns drip water from liquid nozzle but not from needle it seats properly is this normal and will ...
Question about Model 7 Conventional Suction Feed Spray Gun, 1.8mm Tip
AIR BLOWS OUT OF NOZZLE ALL THE TIME ,even with trigger not pressed. disconnect air unscrew needle and check for debris as well as a damaged needle if clean and good replace and adjust till seated in ...
Question about MACH 1 HVLP Pressure Feed Spray Gun, 1.4mm Tip # 6202
Air is coming out of the nozzle but the paint is not coming out. I have an air compressor with spray gun with container connected to the bottom of the gun. I turn compressor on and put it on at 40 psi
siphon tube on cup gun blows into the cup After putting two new repair kits in this Bink's 2001, one right after another and it's not that I've never rebuilt one before, I'm stumped! When I pull the ...
Question about Model 7 Conventional Suction Feed Spray Gun, 1.8mm Tip
I have a binks model 7 repair kit. It has two leather type washers/seals and two smaller leather like washers. I believe two of the go as wipers or seals in on the shaft cap that the needle goes ...
Question about Model 7 Conventional Suction Feed Spray Gun, 1.8mm Tip
I bought a spray gun and wanted to know the difference between the two air caps one is numbered 36SD and the other is 67PD I have a binks spray gun. 67PD PE Used for Zinc rich and other abrasive ...
Question about Model 7 Conventional Suction Feed Spray Gun, 1.8mm Tip
my binks 2001 will not pick up paint under 60 psi, and at that must be very thin! I think I would 1st check to make sure the fluid nozzle is not leaking (sucking) any air. There may be a small piece ...
Question about Model 7 Conventional Suction Feed Spray Gun, 1.8mm Tip
my binks soray gun the air is escaping through the nozzle trigger has solid particles behind trigger. carefully disassemble trigger and blow out debris Be gentle with tiny O-rings as they will ...
Usually answered in minutes!
1 Questions