Washer off balance I had some minor repairs on my washer and now it bounces all over the place. It knocks into the dryer, I even had to take items off my cabinet to keep them from being knocked off ...
a loud knocking noise while the washer doesnt move. Could it be a loose belt or something ? if its a whirlpool top loading washer, sounds like a bad motor coupling.( the machines equivilent to a belt.
Question about Duet GHW9150P Front Load Washer
...washer spins. Clothes come out dry but the knocking is getting worse. Bearing? I had that problem while the washer was under warranty. Luckily my neighbor is a repair man. He removed the front cover ...
My HE3T Elite Washer knocks When my washer runs in wash mode or spin cycle it tends to knock badly. I took off the back panel and rotated the pulley wheel it knocks twice every revolution any ideas? ...
Question about Duet GHW9150P Front Load Washer
Duet Washer rattles and knocks when spinning during spin cycle washer rattles and knocks as if something were lose. I've already insured the washer is level. Pulley bearing in the rear is tight. you ...
...knocking as it reaches maximum spin speed. The problem just started after 6+ years of no problems. I checked and it is still level. I've also cleaned out all of the drain pipes from the drum through ...
How do I replace a knock sensor for a 1992 toyota camry v6 le First, I would like to mention that most knock sensor codes are not caused by the knock sensors, but a mechanical problem with the engine.
washer knocks when on spin like the washer is off balance or not level. sometimes the clothes shifts but this time it still knocks anyway. I have been told it is the shock absorbers when this happens.
...washer is spinning the tub is knocking like the is off balance. I able to move the tub back and forth very easy its like it is not to connected to something. Like maybe a spring is off or missing. ...
Question about RAS8445KQ Top Load Washer
knocking. Could the bearings have gone bad again in such a short time, or could there be something which caused this, like a bend spindle? Is the washer level both front to back and side to side. This
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions