Question about Atlantis MAV6000 Top Load Washer
...gets stuck in the Rinse Cycle. Matayg Atlantis Washing Machine gets stuck in the Rinse Cycle and will continue to rinse for hours. This is the sign of a bad timer. It is not sensing how long it has ...
Question about 24032\24036 Top Load Washer
...washer will get stuck in between cycles My Kenmore 90 series washer works fine washing my clothes, but after the wash cycle it won't go to rinse. I have to agitate the machine a couple of times to ...
stuck in rinse cycle Gets stuck in rinse cycle at 7 min. Will not advance to complete cycle. Time to clean out your filter..................
...Washer is fine until it gets to the rinse cycle. It doesn't sound like it's letting any water in and the timer gets stuck/ doesn't move forward to spin cycle. I've made sure the taps are on, the hose ...
Question about Ultimate Care II LSQ9549L Top Load Washer
...gets stuck on the rinse/spin position The initial wash cycle is fine, but when it gets to the "Rinse/Spin" cycle, it stays there and continues rinsing and spinning forever. I tried to advance to the ...
washer gets stuck in the middle of the rinse cycle. It stops with 20 minutes left showing on the timer. I tried to stop it and restart just doing the rinse and spin, but it continues to stop at the 20
stuck. What is going on with my washer & how do I fix it? Most likely its your water inlet valve..(cold side is not letting water in). Very common problem that usually manifests during rinse cycle
Question about Affinity ATF7000E Front Load Washer
frigidaire affinity washer will get stuck on rinse washer will get stuck on rinse cycle and keep running water through the machine mi lavadora da e91 y key stuk que hago
Question about WHSE5240D Top Load Washer
...washer whre5550K gets stuck in the rinse cycle until I turn it off. It gets stuck in the rinse sycle in all wash settings. If I reset it to Drain and Spin setting, it spins slowly but never spins at ...
...light flashes My Amana washer is stuck on rinse Replaced the drain pump, motor, actuator, resistor and recalibrated and still getting the flashing rinse light flashing after it drains the rinse
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions