Questions & Answers for: washer cycle sync

washer is unusable. Also when you are running a cycle now, after a couple of minutes it gets to a point where the washer makes a thumping sound over and over (still agitating). When it made this sound

cycle where it would drain, making sure I turned the washer off before it cycled back to the 'fill or rinse' cycle. I think the water had accumulated because of the timing of the cycles getting out of

...washer is at the end of the wash cycle.[finished the load,it would be the final spin ,maybe five minutes long.when thats done the timer advances to off]now knowing that thats an off position set on ...

The washing cycles are out of sync with the control knob. My experience is that part of a gear is strip (there ia a few gears in that "timer"). possible cause is that it was turned the wrong way

...washer, model number MVWC6ESWW, when I start the machine, it immediately starts agitating and adding water simeltaneously. At the end of the cycle, the clothes are soaking wet, it seems like it's ...

...sync when you put the knob on wash it does that cycle,then it spins and stops, it does not do second cycle of rinse and spin? have tried the lid switch and it is working Did you let it run through a ...

info screen lit but blank. washer ran fine but unable to see what cycle. Sometimes things can get out of sync. Try unplugging the machine for a few hours to rest the code on the board.

washer shut down midway through cycle, will not power back up Sometimes things can get out of sync. Try unplugging the machine for a few hours to rest the code on the board.

...should I do as it continues to drain non stop as soon as I put it to work Cycle out of sync let it run it's course an see if it resets by itself if not .You will meet to replace cycle control

...washer cycle. You can also add some toothepaste to any undrained water in case their is a clog in some pipes within or connected to your washer. The toothpaste should clear the clogged pipes. Thank ...