Questions & Answers for: Hoover warped lid

Hoover My washing machine won't start because I slammed the lid down. I think it is because when you close the lid, the plastic part on the lid pushes something down (located on the left hand side, ...

Hoover Steam Vac Model F5826-900 Water comes out ok but the vacuum has no suction. Instead it is blowing air instead of pulling up the water. When you put the lid on the recovery tank, you have to be ...

Broken Lid -- where can I get a new one? Last week, one of the two tabs on the back of the lid of our Hoover premier 710 4.0kg washer broke off. Unfortunately, it was the tab that pushes down a little

loss of suction my hoover steam vac stopped suction Make sure the recovery tank lid is on correctly. Also make sure the float on the receovery tank lid is down. float on receovery tank lid stays down ...

maching stopped mid cycle & now has no power, it will not turn on, all fuses are ok It doesn't work at all If your washer doesn't seem to work at all, check these: No power Lid switch No power ...

...lid on the dirty water tank is not on properly or is warped. This will cause a suction leak. If it is warped you can fix it with care. Use a heat source such as a blow torch just enough to soften the ...

i just purchased a floormate. I can't seem to get it to spray cleaning solution. Turn the cleaner off and then on again to determine whether the cause of no suction resulted from the activation of the

My Hoover SteamVac F5915-900 will not pick up water. I've taken the resavor off several times trying to make sure nothing is under it's lid and replaced it as instructed. I don't know wh ...

...work around the problem, when I've finished washing out the condenser I pour very hot water on the warped plastic to soften it, push it back into shape with a wooden spoon handle and hold it there ...