Questions & Answers for: Chamberlain wall unit

wall unit indicates that the code was learned but it still does not open the garage door. I removed the codes for all remote units and reprogrammed both remote units at the motor unit. The remote unit

...unit or by using the wall-mounted control switch. Follow theses steps to program a remote using the wall switch button: 1. Press and hold the button on the remote control 2. While pressing the remote ...

...unit and the wall button. If the wire is smashed the insulation becomes so thin that power will leak thru the insulation and activate the door or interfere with the remote signal. Loosen the staples ...

...unit with a learn button) you must erase the old codes out by holding down the colored learn button until the led light by it goes out. Then press and release the learn button and press the button on ...

...wall mounted unit, I would check if there is actually any current coming it. You can easily do it with volt meter (Harbor Freight tools have a very good one for $7 or so). If no active current, call ...

...unit and the wall button. If the wire is smashed the insulation becomes so thin that power will leak thru the insulation and activate the door or interfere with the remote signal. Loosen the staples ...

...unit and the wall button. If the wire is smashed the insulation becomes so thin that power will leak thru the insulation and activate the door or interfere with the remote signal. Loosen the staples ...

...wall unit it says bad battery replace the battery. is it the battery on the egine unit or is there battery on the wall unit too? because now i lost power on my wall unit there is no light no words on ...

...wall unit. When it finally does respond again it may only travel a few inches and stop again or work correctly for several cycles until unit acts up again. Sensor lights are solid. I can not find any ...

...wall unit, remotes, etc. will not work, Garage Door Opener Shows no signs of having Power After making sure you have power and still won't do anything you have a blown circuit board. PLUG SOMETHING ...