Questions & Answers for: vtec solenoid sensor

...vtec stops working. i have changed all the oil filters and replaced the solenoid but it still wont work properly. What do i do? More than likely its your temp sensor on the front of the engine, Ive ...

...VTEC Solenoid valve and it allows oil pressure into the intake valve rocker arms, the oil pressure opens the VTEC oil pressure switch so the Engine Control Module (ECM) can verify that the VTEC did ...

...vtec solenoid , good Did the map sensor whack , removed and cleaned , had it checked, works Replaced VTEC oil pressure switch. New spark plugs Coils where checked and good Engine temp is good and ...

...malfunction usually cause by a bad vtec solenoid, vtec pressure sensor, low oil level, bad connection. Was oil change done? May want to check the oil level. P1166 is a code for a primary o2 sensor

... How do I fix the problem? I have learned that it might be the vtec pressure switch and vtec solenoid valve. 1.1 o2s(ho2s)(s1) = eng 3.2 map circuit = high input eng 7.1 t p sensor(a) = voltage low ...

...vtec solenoid and the ecu from the 95 and that I will have to wire the vtec into my existing wiring harness. Also I will have all the solenoids/switches/sensor connectors from the 95 wiring harness ...

...Vtec solenoid? If you have a CEL (Check Engine Light) illuminated, and you are getting a "P1259" code, it refers to a "Vtec (Variable valve Timing and lift Electronic Control) System malfunction. The ...

...VTEC SOLENOID OR VTEC OIL PRESSURE SWITCH.MOST TIME CHECK THE OIL PRESSURE BY REMOVING VTEC OIL PRESSURE SWITCH FROM THE LOCK UP SOLENOID AND CONNECT AN ADAPTER BETWEEN THE SWITCH AND THE SOLENOID. ...

...the Vtec solenoid and the head,, My guess is that your oil is pretty bad, or you just had an oil change, either way ,, clean that sensor,, it may or may not work, if not, you'll have to replace ...

...VTEC solenoid, change vtec pre The engine checklight came on and I went to 3 different computer diagnostic centres and the scan showed VTEC system failure. I changed the VTEC solenoid, change vtec ...