off take a multimeter in VDC check the battery voltage at the battery. (should be at 12.5 VDC) If not first charge the battery. Second start the bike, with it running and multimeter again in VDC check
Question about Harley-Davidson Motorcycle Desktop Telephone
off take a multimeter in VDC check the battery voltage at the battery. (should be at 12.5 VDC) If not first charge the battery. Second start the bike, with it running and multimeter again in VDC check
...OFF to ON again without depressing the reset switch or if a speed signal greater than 5 MPH is detected. Diagnostics cannot be performed if system voltage is less than 9 VDC or greater than 16 VDC. ...
...off. If less, may be a dead cell. Recharge or replace the battery. Start engine, should now measure about 14 vdc. This would mean the charging system is working. Less than 14 vdc would mean low ...
vdc. The most common cause of this is loose or dirty battery cables or shorted rectifier. To access codes, turn the ignition switch on for about 3 seconds (one second after the fuel pump stops running
Question about 2004 XL 1200 C Sportster Custom
off. Start the bike and test the voltage at the battery with the bike running, it should be around 12.8 to 13.5 VDC and if you turn the throttle up it should increase to around 14. 5 VDC anything over
off. when i go to start it it just clicks and will not turn over. using a HD battery tender. could it be a fuse, stator or voltage regulator? more likely it's the stator. with a fully charged battery,
Question about 2003 FXD Dyna Super Glide
...VDC unless maybe the bike has JUST been shut off and then it should bleed down into the high 12's after about an hour of sitting. The signal self cancellation is tied to the speedometer and the ...
Question about 2004 FLHTCUI Electra Glide Ultra Classic
...VDC maximum) and the current supply at a high enough amperage to meet the system lighting, ignition, TSM/TSSM, security and accessory requirements plus a minimum of 3.5 more amps (3.5 amps more than ...
...VDC maximum) and the current supply at a high enough amperage to meet the system lighting, ignition, TSM/TSSM, security and accessory requirements plus a minimum of 3.5 more amps (3.5 amps more than ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions