Questions & Answers for: Ford vdc light

...VDC at battery. Help!!! I had one of these trucks many years ago. On mine, I had an electrical short on the drivers side wiring harness. Check the 10 gauge red wires that come from the battery. This ...

...light switch and wiring seems fine. Not getting 12 Vdc to the brake lights with brake depressed. Fuse intact. With the brake pedal switch connector disconnected and bridged out - still no lights. ...

light on . output on battery is 14.7 vdc at idle Start the Van, and with the engine running, take the Negative Cable off the Batttery and see what happens. This Battery Light on could be an indication

...light come on at begining of low idle. voltage at battery terminals during high idle was 14.5 vdc, and at low idle 12.65 vdc. engine speed did not seem to effect voltage supply at this point. battery ...

The engine is running and I am checking the vdc at the batt terminals 15vdc what else do you need to know What are you looking for, or want to do or check out.? Put all lights,blower,A/C on,and see ...

...vdc,i would suspect the voltage regulator,has the belt been checked?11.3 is to low and the light will stay on until voltage is upped?did you fit a [new]alternator?on a good run it should be putting ...

...light came on. When I sarted it back up after I shut it off, the battery gauge dropped and all other power weakened to the point of not being able to drive it. I jumped it and it started but still ...

...cab long bed duelly, the side rear fender lights will not work. I have taken a volt meter set to VDC and I get a reading of 1.6-1.8 vdc on it. I am trying to use led lights I have had them on ...

in the passenger compartment fuse panel, check the fuse on both sides to a known good ground for + VDC. the fuse is CJB ( aka Central Junction Box, cab fuse panel ) Fuse # 18

...start the engine and check again, should be varied betwen 13 to 14 VDC, and turn the head light and A/C on and check to see if dropped bellow 12 that means alternator regulator is faulty. good ...