...mosfet it has this letters > FDS4935 > > In this part inputs 13.2 volts which is ok for the near 12 vdc but it > outputs 1.250 vdc i am 100% sure that this is all the problem > > check it out, and ...
...trying to repair a Vizio 42" LCD HDTV, There is power going into the power supply board, but only 5 vdc coming out of one of the connectors. There are 12vdc and or 24 vdc coming off the power supply ...
...YES, look on the board for voltage test points marked on the board. (SAMPLE!) 3.3 vdc, 5 vdc, 12 vdc, 24 vdc, and so on. Set Meter for DC Volts
m470nv looses back light when warm intermitant problem.12 vdc drops to .8v .can see faint video I would suspect a regulator to be the cause of that issue in that circuit
Question about 47 Inch Class Theater 3d Lcd Hdtv With Internet Apps,
where can I find a schematic for power board 715G4565-P02-W20-003H 5 vdc ok 12 vdc ok 24 vdc ok noo inverter turn on download manual
Question about 2.1 ch. Sound Bar with Wireless Subwoofer - Home Theater Systems
Vizio S3821W sound bar won't turn on. What circuit component is most likely at fault power supply output is 18 vdc. the sound bar
Question about 2.1 ch. Sound Bar with Wireless Subwoofer - Home Theater Systems
...holding the power switch in the "on" position one time. All strips appeared to light up. I have 5.2 vdc going from my power supply to the main board and 66.2-66.4 vdc going from the power supply to ...
Question about 2.1 ch. Sound Bar with Wireless Subwoofer - Home Theater Systems
on the TV power supply board, there is 17.4 vdc, when the printing shows it is to be 12 vdc. The Vled voltage is 16.8 vdc. Bad PS board? This is a Vizio M43-c1 that has audio but no picture and then ...
Question about 2.1 ch. Sound Bar with Wireless Subwoofer - Home Theater Systems
...on the led 1+ and led 2+ pins. With the power on and the connector plugged in, I get 70.2 and 70.1 vdc. With the power on and the connector unplugged, I get 70.0 and 69.9 vdc. What is my next step? ...
Question about 2.1 ch. Sound Bar with Wireless Subwoofer - Home Theater Systems
...by testing the BL_ON voltage on the power board after the backlights go off, you need about 3.3 VDC there, if you see this that means the main board is telling the inverter section of the power ...
Usually answered in minutes!
1,646 Questions
482 Questions
435 Questions
431 Questions
403 Questions