...the charging system. Here is a few tests you can run. First with the bike off take a multimeter in VDC check the battery voltage at the battery. (should be at 12.5 VDC) If not first charge the ...
Question about Harley-Davidson Motorcycle Desktop Telephone
...thanks gavin Here is a few tests you can run. First with the bike off take a multimeter in VDC check the battery voltage at the battery. (should be at 12.5 VDC) If not first charge the ...
Question about 2000 FLHTCUI Electra Glide Ultra Classic
...than 1 ohm you have a broken or poor ground wire. If resistance is less than 1 ohm check for 12 vdc on both sides of the accessory fuse. If you have 12 vdc to only one side, replace the fuse. If ...
...pos. to relay terminal 86) with switch on and starter button pushed the meter should read 1.0 vdc max if that is good black meter lead to relay terminal of solenoid again read voltage then ...
Question about 2005 XL 1200 C Sportster Custom
...hookup tailight wires for an 05 harley davidson sportster xl 1200 c 5 wire hookup Orange/white = 12 VDC Blue = 12 VDC for tail light Red/yellow = Power from brake light switch (to stop light) Black = ...
Question about 2003 FXD Dyna Super Glide
...voltage. I have 13.0 at the battery- key on not running. engine running at Idle I have 14.25 vdc When I bring the rpms up the voltage steadily increases to as high as 17.8 vdc. has the voltage ...
...best indicator of battery condition. Load testing a battery tat is not FULLY CHARGED i.e. at 12.8 VDC can permanently damage it. Fully charge it first and then let it stand for at least an hour ...
...best indicator of battery condition. Load testing a battery tat is not FULLY CHARGED i.e. at 12.8 VDC can permanently damage it. Fully charge it first and then let it stand for at least an hour ...
Question about 2003 FXD Dyna Super Glide
...best indicator of battery condition. Load testing a battery tat is not FULLY CHARGED i.e. at 12.8 VDC can permanently damage it. Fully charge it first and then let it stand for at least an hour ...
...of AGM Battery 12.7 V 100% 12.6 V 75% 12.3 V 50% 12.0 V 25% 11.8 V 0% If your battery is 12.6 VDC or higher when you check it the regulator is likely good. If you were to check the voltage of ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions