Pro-form 320x treadmill slows down then motor stops. While walking on the treadmill the motor starts going erratic them stops.Only turns on for 20 seconds at a time... Sounds like it is overheating, ...
When I switch on my Trimline treadmill 1050.2E, the entire display panel lights up for a few seconds and then it all goes blank except a message showing 'E2' on its screen. After that none of the ...
EXP 1000 starts and stops after about 7 minutes. Irregular speed changes during work out speeding up and then stopping. Thanks, Bill Hutton I am not familiar with this model but it sounds like a speed
...motor error 2" 1)VSD(variable speed drive) MICROPROCESSOR eprom/sram failure: Exchange VSD board.2) Belt speed pickup,failure in the speed pickug, to due motor, wiring or controller ...
Question about Tc 916 Treadmill Vsd Board
I have an E7 on my treadmill its brand new whats wrong lubricated it 1= this errro means 2 alternatives:a= display board is erratic: adjust the reed switch see the diagram attached, tight the ...
Question about Ntr 800 Treadmill Lift Motor
I have a Precor 9.33i Treadmill. It works perfectly until I start to walk/run on it and then it shuts down. What is causing this? LUBE THE deck belt, this happen because the system protect the ...
Tm com error 1 adjust the Speed sensor, test for open or faulty, clean it, tight the plug or connector very well. see the diagram attached. 2) Test the input voltage motor, if there are the motor need
system overload The treadmill shuts down and gives the error "system overload" when the customer is sprinting. Step 1: see the video and lube the rollers bearings too Step 2:test the input voltage ...
How can I get the console to work? I recently had the main control board repaired and the motor tested, which was fine. When every thing was connected and the machine switched on, the console showed "
Question about T914 Commercial Series Treadmill
I have a nautilus T914 commercial treadmill. What kind of receptacle do I plug it into? The motor is 230 volts. The treadmill has a plug where one of the prongs is flat and the other one is straight. ...
Usually answered in minutes!
17 Questions
18 Questions
2 Questions
3 Questions