...fuel injection. It maybe the fuel pressure rugulator inside the EFI Unit. Sorenson makes a rebuild kit with all the gaskets, screens and regulator for about $30. An EFI is the most simplest carb you ...
Not getting power to the fuel pump. I have power at the relay but not at the connection on the pump you may have a bad relay. use an ohmmeter to check for continuity to find where on the relay plug ...
idles rough till about 1600 rpm. tried injection pump. starts good 1600 is not idle speed my friend, 600 or 700 is idle speed. You need a tuneup on your 13 year old vehicle.
...less than 4 psi. The fuel transfer pump is located on frame rail under drivers door, If fuel pump is bad replace it. If that doesn't solve your problem, you may have a bad injection pump. Please ...
my 1998 gmc 2500 has a fuel gauge problem It bounses around a little every time you turn the key on but mostly sits at the bottem Any ideas. Thanks Your problem is a bad fuel level sensor.The only bad
vapor system is supplied by the engine. If the valve was clogged the vacuum would never reach the system in the first place. However as fuel is pumped out of the tank, air needs to be able to enter to
where is fuel sensor 1997 2500 sierra truck What engine do you have. Are you looking for the fuel level sensor or the fuel pressure sensor.
new fuel pump and it still wont start the wire still has power but still wont start, but if i go right from battery to fuel pump with 12 volts it will start Check for proper Ground to fuel pump ...
Question about 1988 K2500
How do I jump a fuel pump relay of a 1988 GMC K2500 with a 5.7L to get power to a sending unit from a 1998 GMC C1500 with a 5.0L V8? Doing a gas tank swap and the fuel sending units are completely ...
Usually answered in minutes!
80 Questions
47 Questions
30 Questions
28 Questions
10 Questions
