Questions & Answers for: Chevrolet Silverado vapor lock fuel injection

...vapor lock ecspecially the 2000 models. Do not tighten the gas cap past 1 click. There is a tube that runs from the top of the tank down and this gets hot and collapses or burns in half. We just ...

...fuel filters and rebuilt distibuter still have vapor locl problem Its possible thats its not vapor locking! check the electrical plug the plugs on the fuel pump and look for a melted connection or ...

...after running for several hours. Short trips, the truck runs fine. Could be vapor lock in the fuel system. Next time it does this, stop and try removing the fuel filler cap... Hope this

fuel injection pump runs 30 psi minimum some of them quite a lot higher than that. a carb cannot have more than 7psi without bypassing the float in it and overflowing the carb with fuel. when going to

...Fuel saturated vapor canister. 4- Failed EVAP vent solenoid.  -------- The cost of the vent solenoid valve is near to 30 bucks. And the valve is located near the gas tank. Thanks. you can rate ...

where is the fuel vapor canister located on a 2000 silverado The vapor canister is located under the vehicle near the fuel tank. It is made out of black plastic and has plastic lines running to it.

vapor lock condition. Fuel pressure should be around 56 psi and hold steady for at least 45 minute to an hour. If it drops within a couple of minutes to check valve in the pump is probably bad and the

...hr or so is the motor running hot? what year is your car? what motor does it have? if its overheating it could be boiling the fuel and vapor locking that's all i can think with such lil info good ...

...gasoline 1983 Chevy Silverado runs really rough black smoke what's the problem? It was running fine now it runs real rough it has a throttle body fuel injection check the map sensor vacuum hose

how do i get my 2000 silverado to stop vapor locking No vapor lock on a fuel injected motor Basically 1988 on Need to provide details of the problem How about discussing the issue with a repair shop?