Questions & Answers for: Poulan valve tank

...the line and attach to tank side of purge valve. Small line from purge valve goes to bottom fitting on carb. Small line from left side of fuel tank has the filter and goes to top fitting on ...

...tank were 2 peices of fuel line that is disntegrating a connector, some sort of flexible valve (like a one way rubbr valve to let fuel in and not out and a long cylinder with a connection (I assume ...

...valve is floating in the tank. where does it go? i am not familar with this brand but i can give some suggestions. this probably goes on the end of a breather line for the tank or on the tank itself. ...

...tank. The duck bill valve (vent) is usually attached to a hard plastic nipple that the hose attaches to (in the tank). To route the fuel lines through the holes in the fuel tank, take a scissors and ...

.... Fuel lines get flaky when they deteriorate. Your primer bulb may be leaking also. The check valves in the carburetor control the flow of fuel in and out of the primer bulb. The carb may need ...

...tank. The valve that is there is called a duckbill valve because of the way it looks. Inspect the cap and look for dirt or debris also if it is able to open and close. Some other makes of chain saws ...

tank (Poulan 2800 chain saw) no longer has a one-way valve. Thus, fuel leaks when trying to use the saw. Your solution was to replace with a new valve. Problem: None is listed in the Operator's Manual

...and replae it ,little help on why? fuel cap venting or what? yes there is a vent some have a little valve on the back of the cap some have a second fuel line with the valve on it look for it floating ...

check valve oil is not getting to the bar from the oil tank. Check the filter in the tank on the line. It may be plugged.

tank and retrieve the fuel filter attached to the hose. Carefully remove the filter from the hose and with your finger over the end of the hose pump the primer. You should hold a vacuum. If the primer