Questions & Answers for: General Electric valve tank

...tank valve on, turn tank on side & locate valve stem on bottom side. 3) Remove stem cap. 4) Drain all water out of tank through open RO faucet into sink. (Continue to leave RO faucet open throughout ...

...i can not get any hot water presure. the tank is full and hot. no water flows. Check by-pass valves at back of tank for wrong positioning. Cold goes in bottom, hot out top and both should be ...

...valve to have the tank rust out next month. I'ld replace the whole unit. Also, install a drip pan, under it and a WAGS safety device. Any water in the pan and the WAGS will shut off he Water and Gas. ...

...However, if you install a check valve you will also need to install a small pressure tank or pressure relief valve between the water heater and check valve to balance the pressure in the

...off the old valve, the water in the tank will start flowing out. You need a way to handle this. Prior to removing the old valve, turn off the gas and turn off the water supply to the tank. Good

tank was full the T&P valve started to let water come out of the valve, causing a trickle on my basement floor. When I turned the cold water input off the trickle stopped. I turned on the power to

...tank. If TP valve is on side of tank, then open drain on side of tank and drain water until it is lower than valve level. Open bathtub spigot to let air into line. ...

...valve can also be caused by overheated tank. Turn down thermostat. Install expansion tank on incoming cold water line. Electric heater: thermostat or element may be bad and tank needs troubleshooting ...

water seems to be leaking from the top lid of my ge water heater Make sure any water valves (Cold or Hot) for water heater are not leaking first. Gate valves may leak at the packing nut over time and ...

...tank.jpg Expansion tanks are installed when TP valve is constantly drizzling hot water due to very hot temperature settings. Or when water pressure is high, etc It's also smart to install ...