...end noise is valve related pushrod adjustment could be off hope correct piston to cylnd clearence is right, piston slap or nocking sounds like top end noise also hope this helps give me a rate ...
...valve noise on my 06 Road King. I've got 14k miles on it now. I've been running 10-40syn oil in it. Should I run 15-50 or just take it to the shop and get the valves adjusted. The noise is not scary ...
valve noise 2006 road king 2006 road king with 20,000 miles starting to hear alot of valve clatter.have heard maybe the timing chain tenseniors? Hello redevil67...This is normal for the HD engine, it ...
...noise like the lifters are loose Had the same issues when we upgraded from a shovel head to a newer bike. HD tried telling us, "it's a Harley. .." to which my responses was so..... it is ticking, one ...
Question about 2003 FXD Dyna Super Glide
...valve train noise is common in an engine with a few miles on it. However, if people are asking you what's that noise when you pull up, you need to have it checked out. Pull the top covers off the ...
...seams to be like a bad ticking noise that seams to be coming from the lower end of the motor. is this normal. could that mean a valve job is due ..??????.help help valve noise comes from upper ...
valve noise as the bike gets older, however, this noise is only noticable at Idle. If you are getting a loud enough noise at crouse speed to the point of being annoying then the chances are you have a
...valve springs. Look and see if there is anything that might be causing your noise. Now, keep in mind that a Harley engine is of an old design. It is a pushrod type engine with rocker arms that open ...
noise that will change with rpm's (may quieten when accelarating/deccelerating). If it is the valve clearance, it is not an immediate concern, but should be adjusted to prevent unnecessary wear on
Question about 2000 FXD Dyna Super Glide
...valve seat problem, air noise coming out of the intake or exhaust ports. What it will not diagnoise is a failed valve seal usually from improper installation or rotating engine before lifters bleed ...
Usually answered in minutes!
331 Questions
67 Questions
3 Questions