valve covers gasket leak oil does anyone have agood ideas of how to replace it? To replace the valve cover gaskets on a Sienna: The front one is easy. The difficult one is the other side, closest to ...
...gasket on to the thermostat. b) Align the thermostat jiggle valve with the upper stud bolt and insert the thermostat in the water inlet housing. HINT: The jiggle valve maybe set within 15 deg of ...
...valve stem seals. The first problem (white smoke) will requre the removal of the engine head to replace gasket and have head face machined, The second problrm (blue/grey smoke) will require further ...
...its a valve cover leaking, sometimes it just needs to be tightened from many miles of vibration, they loosen up, if that checks out ok, try underneath ,, the oil pan gasket and the oil filter seal
...valve. It is housed on the throttle body. Take it off and clean it out with carb cleaner (B-12) and a toothbrush. Make sure you replace the gasket with a new one when putting it back on. Trying to ...
...2 MOTOR 3.0 TOYOTA SIENNA 2001 Then the cylinder head has to come off That is a major repair if the valves are the issue or the head gasket If that is a van type vehicle, I would get rid of it & ...
...valve cover gaskets with a 3.0 on a 2000 toyota sienna Make sure there is no oil on the cover where the gasket touches it. Apply a silicone adhesive to only ONE side of the gasket, never both. The ...
...valve starts to open and the temperature that it is fully open (if it opens). The opening temperature will be about 85 degrees c and fully opened at about 95 degrees c. If this is the case then look ...
...valve cover gasket Lose the engine cover,disconnect all the sensors on the valve cover,then lose all the bolt that thighten it the cylinder. Remove the valve cover{gently} and remove the gasket nd ...
Usually answered in minutes!
572 Questions
501 Questions
377 Questions
382 Questions
333 Questions
