Question about 1987 Bronco
...valve cover gasket on the passenger of my 1987 ford bronco and cannot seem to get to it? trying to replace the valve cover gasket on the passanger side of my 1987 ford bronco 302 remove the valve ...
...gasket but no water in the oil and the engine does not smoke. maybe I hear valves rattling, possibly a lifter, but really no power, had a hard time coming home it is a 5 spd. manual and topped out at ...
valve, clogged air filter 3.Fuel pump is not delivering sufficient fuel to the carburetor/fuel injectors. 4.Leaking head gasket.Perform a compression check, could be uneven or low cylinder compression
...valve cover gasket The egr is only active when the engine is under load, it should not make a difference when you pull the line off. The idle going up and down is due to a vacuum leak, could be the ...
...valve cover gaskets, head gaskets, intake manifold gasket (if equipped; the gasket that is); and, since you're pulling your heads, you may as well replace your push rods, lifters and rocker arms. If ...
valve covers on my 1990 bronco 2 v-6 No torque specs. Don't use sealer, that can cause the gasket to slip. Put cover in place, start all bolts, loosely snug all, hand tighten from bottom two, top two,
...gasket is $31-53.00 dollars fel-pro was the lowest at $31.00. you will also need intake,valve cover. now the big question is, what MOTOR does this have ??? That vehicle is only worth $ 700 - 2400.00 ...
...and might pull the EGR valve off and inspect. If the EGR sticks open slightly that would make a vacuum leak. I have seen both intake gasket on 5.0 and the 5.8 do this as well as an old EGR
burnt oil smell when driving 96 ford bronco when driving this vehicle there is an unexplained burnt oil smell. Not sure where its coming from. leaking valve cover gaskets
Usually answered in minutes!
227 Questions
224 Questions
178 Questions
137 Questions
124 Questions