Question about K-3386-0 Rialto one-piece round-front toilet with seat and left-hand
...valve bowl gasket so I remove the old flish valve and when to replace it with a new one. I cannot compress the flush valve gasket to twist the flush valve into the bowl. I contacted Kohler and they ...
Question about - Toilet - One-piece - Santa Rosa - K3323-52
...is falling to pieces. Cant see how to get the old gasket off. The top of the pipe above the flush valve is threaded. Unscrew it, and you will be able to remove the flush valve and replace the
Question about - Toilet - One-piece - Gabrielle - K14257-WS-47
...valve on my kohler 3386 toilet to fit in the hole with the gasket. The foam gasket is quite thick. Is there a trick to doing this short of mutilating the thing? The foam gasket stays on the inside of ...
Question about KOHGP51487 Authorized Original Replacement Part Tank Gasket For All
...gasket and installed a new kohler flush valve. I have no leaks but the tank continues to slowly lose water. Did I not tighten the large white that disappears into the gasket tight enough or did I not ...
Question about - Toilet - One-piece - Santa Rosa - K3323-52
...able to remove the flush valve and replace the gasket. I am assuming we are talking about the same here is a link that has all the parts: ...
gasket at the bottom of the flush valve. Is this replacable without replacing the entire flush valve, and is there any sealant necessry for the installation? Hello, W/D here. With the water off, drain
...Tighten the bolts uniformly. You mention that the flush valve was hand tightened only. If this gasket is not snug (a bit more than hand tight), a leak can occur there as well. Best regards,
Question about - Toilet - Two-piece - Highline - K3427-RA-G9
...there are 2 or 3 tank to bowl bolts remove bolts then there is a big nut under tank to bowl gasket undo large nut then install new flush valve,gasket and bolts be sure to install as old one came
...allwways means a bad head gasket if this happens , and most head gasket failures are from overheated blocks meaning a warped head face but on rare occasions it could allso be a bad valve stem ...
Usually answered in minutes!
50 Questions
35 Questions
40 Questions