...valve. I bought a new gasket but can't get the old one out. Is this gasket glued in? If so how do I remove it and what do I use to glue the new one down????? Thanks. If the spider gasket in the ...
...gasket in my Hayward valve three times. I've tried without glue, with silicone sealer and it does not hold. The same two spokes always curl up or lose their seat. (The silicone came with the gasket) ...
...valve gasket, please e-mail me the complete model number of the valve to [email protected] and I would be happy to help you further once I have more information. To affix new gasket simply put ...
Question about SAND FILTER, PRO SERIES
...new one in properly. Typically, it is the gasket that goes and not the valve. Remember, you can only turn the handle in a clock wise direction - never backward. or is that counter clock wise ...
...gasket in the gas valve compartment has blown. They want me to replace the whole gas valve at a small cost of around $375.00. Can I just replace the gasket? Better yet, just put the gasket back in ...
...gasket. With the valve set to "filter" and the pump OFF you can remove the screws on the top of the valve to check the gasket. It looks like a pie-chart, and usually called a "spider gasket". Check ...
Question about Pro Series 18" Above Ground Pool Sand Filter System with Pump
...valve and remove the assembly. The gasket that usually goes bad is the "spider gasket", it looks like a pie-chart. Check this gasket for any tears or bends in the rubber, if you see any replace it. ...
Question about SAND FILTER, PRO SERIES
...valve multi-port gasket seal, commonly referred to "Spider" gasket. This has Failed. And allowing water to pass between the many ports within that valve, mainly between the "Return" port and the ...
gasket, I use gel superglue. If you have a newer 714 valve it is much harder. I suggest removing the screws at the top and taking the whole key handle assembly into your local pool store for help. The
...is placed in. On the filter valve near the handle, you will see a Part number. That will provide you access to a diagram for that particular valve, Then locate the gasket within it and replace
Usually answered in minutes!
774 Questions
131 Questions
104 Questions
113 Questions
87 Questions